2Gig Smoke Detector


Smoke Sensors should be installed with every security system. Most people think about a fire after one has occurred. Unfortunately that is the case with a security system also. Obviously the time to think about protection from burglary and fire is before one happens. Fires killed more Americans in 2006 than all other natural disasters combined. Those statistics should cause for everyone to install at minimum a working smoke sensor.

Types of Smoke Detectors

It is not necessary to have a complete security or fire alarm panel installed to get fire protection for your home. There are many different types to choose from that range in price from $7.00-$35.00. The range in price is due to multiple options that are available. You can get smoke detectors that incorporate a heat sensor and some also have built in carbon monoxide detection. You can even purchase some that will talk to you during an alarm and you can even have them with a built in escape light.

The 2Gig Smoke Detector incorporates a built in heat detector and has a transmitter that communicates with the control panel. If there is an alarm, the system will ring the audible device that is attached to the system. If the system is monitored by a central station then the authorities will automatically be notified. These home security devices are programmed as a 24 hour device. This means that an alarm will trigger regardless of the mode of operation that the system is set to.

Central Station Monitoring

The monitoring of your alarm system is not a required option. The advantage of having your system monitored is that you have 24 hour protection. If you are not at your home in the event of a break in or a fire your home is still protected. The monitoring agency is sent an alarm and they will automatically jump into action and initiate a series of procedures to contact you Bug Detector and also contact the required authorities.

This smoke detector is for use with the 2gig GoControl Panel. The device is completely wireless and needs no additional wiring to activate the control panel. All power is provided by 2-3volt lithium batteries.

Installation of Smoke Detectors

The threat of fire is highest when the occupants of the living unit are asleep. The fires typically occur in areas located outside of the sleeping area. Smoke sensors should be located in accordance with NFPA 72. The basic location is outside of the sleeping area so that occupants can be notified while they are sleeping in the event of a fire. One smoke sensor is required if there is only one floor. If there is a second floor there should be an additional smoke sensor. This detector should be located near the stairs leading up to the second floor. If there is a basement there should be an additional smoke sensor located at the stairwell leading up to the 1st floor. This is the minimum required amount of smoke sensor but additional detection will provide a more reliable early detection in the event of a fire. The installation of smoke detection in kitchens, attics or garages is not recommended. Additional fire detection can be obtained by the use of heat detectors. The use of 2Gig smoke detectors provides excellent protection against fire.

Testing your Smoke Detectors

During the initial installation of a new 2Gig-smkt2 detector you will need to test it to ensure proper operation. Once the new smoke sensor is programmed into the control panel you can test the operation by pushing the test button located on the outside of the detector. The detector also incorporates a sensitivity test to let you know if the detector is too sensitive or not sensitive enough. You should test your sensor by using actual smoke that is introduced to the chamber so that the detector can be fully tested. This can easily be done by using canned smoke.

Leave a Reply

Your email address will not be published. Required fields are marked *